weiheng EMS100
Weiheng
Supported Devices
| Device Type | Modbus TCP (Ethernet) | RS485 | Curtailment |
|---|---|---|---|
| EMS100 | ✅ | ❌ | ⚠️ |
- Protocol driver:
Weiheng EMS100 Modbus TCP - Default TCP port:
502
Configuration
Ethernet Connection
Make sure the Controller and the Weiheng EMS100 are connected to the same network.
- Connect the EMS100 Ethernet port to the same switch/router as the Controller.
- Ensure the EMS100 has a reachable IP address.
- TCP port must be 502 .
For correct ethernet wiring: Follow the the guidelines for ethernet wiring.
Device settings
⚠️ Make sure the device Direct power control read-only mode is off. If it is on we can't send commands with the EMS100.