AppareilsOnduleurs hybrides photovoltaïques et onduleurs de batterieSolisOnduleurs Solis raccordés au réseau
Solis S-Series (raccordé au réseau)
Câblage
La connexion RS485 s'effectue via le connecteur COM à 16 broches situé au bas du convertisseur.
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| RS485 IN A | RS485 A | RS485_POS | RS485 A | TX+ |
| RS485 IN B | RS485 B | RS485_NEG | RS485 B | TX- |
| N/A | RS GND | GND | Not available | G |
Configuration
RS485
Avertissement
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.
Par défaut, l'onduleur est configuré sur l'adresse 1. Celle-ci peut être modifiée via l'écran de l'onduleur. Vous trouverez la procédure au chapitre 7.3.2 du manuel.
Last updated December 10, 2025Edit this page