Dispositivos Suportados
| Device Type | Modbus TCP (Ethernet) | RS485 | Curtailment |
|---|---|---|---|
| PS-PULSE-INV-6KW | ❌ | ✅ | ❌ |
| PS-PULSE-INV-8KW | |||
| PS-PULSE-INV-10KW | |||
| PS-PULSE-INV-12KW |
Cabeamento
RS485
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| RS485 A | RS485_POS | RS485 A | TX+ | |
| RS485 B | RS485_NEG | RS485 B | TX- | |
| RS GND | GND | Not available | G |
Configuração
Aviso
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.
- Defina o modo de operação para Auto Consumo.
- Defina Zero Export para Desabilitar.
- Defina Controle Remoto para Habilitar.
- Defina o endereço RS485. A taxa de transmissão padrão é 9600, se não for, defina para 9600.
- Defina a corrente de carga. Defina a corrente de carga.
Aviso
Aviso
IMPORTANTE! Para um 5KT defina para 100 Para 10KT defina para 160
- Defina Acoplamento AC para Habilitar.
