Energreen Omvormers
Ondersteunde Apparaten
| Device Type | Modbus TCP (Ethernet) | RS485 | Curtailment |
|---|---|---|---|
| Stor | ✅ | ✅ | ✅ |
| PV Max | |||
| Hybrid |
Bekabeling
De SmartgridOne Controller en de Dyness-omvormers communiceren via RS485 of Ethernet.
Ethernet
Voor correcte ethernetbekabeling: Volg de richtlijnen voor ethernetbekabeling.
RS485
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| A | RS485 A | RS485_POS | RS485 A | TX+ |
| B | RS485 B | RS485_NEG | RS485 B | TX- |
| N/A | RS GND | GND | Not available | G |
Configuratie
Zorg ervoor dat modbus is ingeschakeld:
- Ga vanaf de hoofdpagina naar "Device"
- Klik op "Powerhouse Settings"
- Schakel "Modbus TCP Server Enable" in
Zorg ervoor dat de omvormer is ingesteld op Remote EMS Mode:
- Ga vanaf de hoofdpagina naar "System"
- Klik op de drie puntjes naast de installatienaamruimte
- Klik op "System Settings"
- Klik op "Operational Mode"
- Selecteer "Remote EMS Mode"
Schakel eventuele netlimieten uit:
- Ga vanaf de hoofdpagina naar "System"
- Klik op de drie puntjes naast de installatienaamruimte
- Klik op "System Settings"
- Schakel onder "Operational Parameters" "Export Limitation" en "Import Limitation" uit
- Stel "Grid Connection Point Reserve Power Control Method" in op "Power Per Phase"
Waarschuwing
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.
Last updated February 18, 2026Edit this page