Schneider-Electric IEM 2100 Serien Energi Målere
Understøttede enheder
IEM 2100 Serien er enfasede elmålere.
| Device Type | Modbus TCP (Ethernet) | RS485 |
|---|---|---|
| Schneider-Electric iEM 2100 Series | ❌ | ✅ |
| Schneider-Electric iEM 2150 | ||
| Schneider-Electric iEM 2155 |
Tilslutning
IEM 2100 serien kommunikerer via Modbus RTU over RS485.
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| D1 (+) | RS485 A | RS485_POS | RS485 A | TX+ |
| D0 (-) | RS485 B | RS485_NEG | RS485 B | TX- |
| 0V / Shield | RS GND | GND | Not available | G |
Se venligst i enhedens manual for præcise pin-placeringer, da disse kan variere en smule mellem specifikke undermodeller (f.eks. iEM2150 vs iEM2155).
Konfiguration
Advarsel
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.
Kommunikationsindstillinger
Sørg for, at enhedens indstillinger matcher driverens egenskaber som defineret nedenfor:
- Baud Rate: 9600, 19200 eller 38400 (Standard er ofte 19200)
- Parity: Jævn, Ulige eller Ingen
- Stop Bits: 1
- Data Bits: 8
Tjek enhedens manual for, hvordan du går ind i elmålerens konfigurationsmenu for at sætte Modbus-adressen og Baud Rate.