Power-Sonic

Obsługiwane urządzenia

Device Type	Modbus TCP (Ethernet)	RS485	Curtailment
...	❌	✅	❌

TODO: Uzupełnij tabelę

Okablowanie

RS485

RS485 Wiring

• For correct RS485 wiring: Follow the guidelines for RS485 wiring.
• If the wiring shown in the table below is incorrect, please let us know.
• There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
	RS485 A	RS485_POS	RS485 A	TX+
	RS485 B	RS485_NEG	RS485 B	TX-
	RS GND	GND	Not available	G

TODO: Uzupełnij piny kabla w tabeli.

Konfiguracja

NOTE: RS485 Device Addresses

• You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
• Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
• For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.

1. Ustaw tryb pracy na Samo Zużycie

2. Ustaw Zero Export na Wyłącz

3. Ustaw Zdalne Sterowanie na Włącz

4. Ustaw adres RS485. Domyślna prędkość transmisji to 9600, jeśli nie, ustaw na 9600.

5. Ustaw prąd ładowania. Ustaw prąd ładowania.

WAŻNE!

Dla 5KT ustaw na 100 Dla 10KT ustaw na 160

6. Ustaw AC Couple na Włącz