Power-Sonic

支持的设备
Device Type | Modbus TCP (Ethernet) | RS485 | Curtailment |
---|---|---|---|
... | ❌ | ✅ | ❌ |
待办事项:完成表格
接线
RS485
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
---|---|---|---|---|
RS485 A | RS485_POS | RS485 A | TX+ | |
RS485 B | RS485_NEG | RS485 B | TX- | |
RS GND | GND | Not available | G |

TODO: 完成表格中电缆的引脚。
配置
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.
- 将工作模式设置为自耗

- 将零出口设置为禁用

- 将远程控制设置为启用

- 设置RS485地址。默认波特率为9600,如果不是,则设置为9600。

- 设置充电电流。 设置充电电流。
重要!
对于5KT设置为100 对于10KT设置为160

- 将交流耦合设置为启用
