跳到主要内容
Ampowr

Ampowr 逆变器

支持的设备

Device TypeVariantsModbus TCP (Ethernet)RS485
Ampihome单相
三相

接线

SmartgridOne Controller 和 Ampihone 逆变器通过 RS485 或以太网进行通信。

以太网

正确的以太网接线: 请遵循 以太网接线指南

RS485

RS485 Wiring
  • For correct RS485 wiring: Follow the guidelines for RS485 wiring.
  • If the wiring shown in the table below is incorrect, please let us know.
  • There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
DeviceSmartgridOne Controller model OM1SmartgridOne Controller model IG8RS485-USB converterRS485-Ethernet converter
针脚 7 (白棕色) RS485 ARS485_POSRS485 ATX+
针脚 8 (棕色) RS485 BRS485_NEGRS485 BTX-
不适用 RS GNDGNDNot availableG
Ampihome 单相接线

配置

Ampihome 单相

Ampihome 单相需要设置为从属次级端口:

  1. 打开 ESS Link 应用
  2. 在右下角选择 “我的”
  3. 选择 “我的设备”
  4. 选择设备的 “通信编号”
  5. 选择 “参数设置”
  6. 将 “工作模式” 设置为 “定时充电模式 (C&D)”
  7. 在右上角选择 “高级”
  8. 将 “BMS1 RS485 多路复用” 设置为 “从属次级端口”
Ampihome 设置 1
Ampihome ��设置 2
NOTE: RS485 Device Addresses
  • You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
  • Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
  • For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.