支持的设备

Device Type	Modbus TCP (Ethernet)	RS485
Schneider-Electric PM 820	❌	✅
Schneider-Electric PM 850
Schneider-Electric PM 870

接线

RS485 Wiring

• For correct RS485 wiring: Follow the guidelines for RS485 wiring.
• If the wiring shown in the table below is incorrect, please let us know.
• There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
D1/+	RS485 A	RS485_POS	RS485 A	TX+
D0/-	RS485 B	RS485_NEG	RS485 B	TX-
0V	RS GND	GND	Not available	G

配置

NOTE: RS485 Device Addresses

• You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
• Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
• For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.

查看设备手册以了解如何进入电能计的配置菜单。